Drinking Water
Reverse Osmosis is the most economical water treatment method that will remove the widest spectrum of contaminants. This is the process from which bottled water is made as well as the technology involved in many other markets today as well. Reverse osmosis will typically remove 90-98% off all contaminants in the water. The effectiveness of RO depends on incoming water quality, incoming water temperature, and the incoming pressure. We offer a variety of residential reverse osmosis systems for drinking and cooking. All of our reverse osmosis systems will provide excellent quality water for you and your family. All of these systems utilize NSF certified components and are sent to you with everything necessary for a basic installation (see list below). In most cases all filters except the membrane should be replaced every 6-12 months. Membranes should typically be replaced every 2-3 years depending on water quality.
All systems include the following:
- Sediment, carbon, membrane filters
- Feed water shut-off valve
- Storage tank w/ shut-off valve
- Mounting hardware
- Plenty of polyethylene tubing for each connection
- Drain saddle
- Drinking water faucet
- System sanitizer
- Oring silicon
- Instruction manual
- Technical support for installation assistance
Unsure about which drinking system is right for you?
If you are unsure about which drinking system is right for you, just give us a call. One of our water specialists would be happy to help you decide!
Typical RO contaminant removal list
Our Aqua Pure system is a standard 5 stage RO system. This unit starts with polypropylene sediment pre-filter to remove sediment and debris. Then, the water will go through (2) carbon block pre-filters to eliminate the chlorine or Volatile Organic Chemicals in the water. Following this pre-filtration the water forced through a semi-permeable. This is what is doing most of the purifying of the water. The product/permeate (good) water is then sent to the storage tank while the concentrate (bad) water is sent to the drain. When water is called for at the faucet, the high quality drinking water that is in the storage tank is sent through a final Granular Activated Carbon polishing filter, which freshens up the taste and polishes your drinking water.
The Aqua Pure HP (High Pressure) is a great system for someone that is looking for an RO system that will not only provide great pressure at the POU (Point of Use), but can also accommodate refrigerators and icemakers. This system utilizes a non electric permeate pump that provides good constant pressure to all outlets that it feeds. In many cases, a standard RO system will not provide satisfactory results when connected to a fridge. The Aqua Pure HP will also fill up the storage tank more quickly and reduce the overall waste water from the RO as well. This unit can also be installed in remotely as well.
Our Aqua Pure QC (Quick Change) RO system is becoming very popular! The reason is because this system is very innovative and makes maintenance and filter changes very simple and easy. Every filter in this system is totally encapsulated. In order to change these filters, the filter is lifted to a 45 degree angle. This will immediately shut-off the system. The filters are then twisted ¼ turn counter clockwise to release. The new filter is then twisted clockwise and locked into place. These filter changes are so quick and easy that a complete filter replacement of all four filters can be done in less than five minutes! No wrench, tools, stress, or mess are necessary for this filter change. This filter change is so simple that it can be performed by children and even most elderly folks. This unit is also more efficient than most reverse osmosis systems today.
Reviews
What People Say About Us
24 Hours Response Time
Quick turn around time for your queries. Our representative will be in touch with you within 24 hours.